In these situations use one of the following.
12v led light strip installation.
Wire multiple strips of lights together.
Slide the end of the strip into one end of a connector clip and snap it shut.
Peel the top layer off to expose the ends.
One or two reels of 12v led light strips you may need more depending on the project.
Place a connector in the other side of the clip so the strip can lay flush along the corners.
Led strip mounting clips mounting brackets for strips.
Extra adhesive tape 3m tape that you put on the surface before the strip to double the bond.
Installation tool list for 12v led light strips the tools you need for a complete installation are below.
I was able to do this without any drilling into the tailer by utilizing th.
You ll need to plan to do the following.
Start by wiring all strips or strings of lights together.
Now you could also want full on waterproof led strip lights ip67 if your lights are anywhere near your boats outer edge or even on the hull itself.
Depending on where the lights are located on your boat this answer could change but at the very least we suggest weatherproof led strip lights which are graded ip65.
This means that all of the red wires will be connected together to run to the switch.
Because everything is already 12v you want to wire them in parallel.
1 2 peel back the adhesive tape backing enough to accommodate the connector.
To get started with your diy 12v led light strip installation you need some tools.
3 insert strip light into the connector so that the connector teeth will insert into the bottom of the strip light.
Use a sharp knife to make a slit along the black lines between the light and the end of the led strip.
A video showing the installation of an led light strip under the awning on our rv.
1 cut strip light at the cut mark using the cutting interval instructions on pg.